Wildcard mask in EIGRP

The network command in EIGRP uses a classful network as the parameter by default, which means that all interfaces inside the classful network will participate in the EIGRP process. We can enable EIGRP only for specific networks using wildcard masks. The syntax of the command is:

(router-eigrp)#network IP_ADDRESS WILDCARD_MASK

We will use the following example network:

Wildcard mask in EIGRP

The router is directly connected to three subnets. Let’s say that we want to advertise only the subnet in EIGRP. We can use the wildcard mask of to do this:


Using the show ip protocols command we can verify that only the subnet is included in EIGRP:

R1#show ip protocols

Routing Protocol is \"eigrp 1 \" 
Outgoing update filter list for all interfaces is not set 
Incoming update filter list for all interfaces is not set 
Default networks flagged in outgoing updates 
Default networks accepted from incoming updates 
EIGRP metric weight K1=1, K2=0, K3=1, K4=0, K5=0
EIGRP maximum hopcount 100
EIGRP maximum metric variance 1
Redistributing: eigrp 1
Automatic network summarization is in effect 
Automatic address summarization: 
Maximum path: 4
Routing for Networks:
Routing Information Sources: 
Gateway Distance Last Update 
Distance: internal 90 external 170

Notice that is listed under the Routing for Networks column. The other two networks ( and are not included in EIGRP.


Prerequisites for 200-301

200-301 is a single exam, consisting of about 120 questions. It covers a wide range of topics, such as routing and switching, security, wireless networking, and even some programming concepts. As with other Cisco certifications, you can take it at any of the Pearson VUE certification centers.

The recommended training program that can be taken at a Cisco academy is called Implementing and Administering Cisco Solutions (CCNA). The successful completion of a training course will get you a training badge.

Full Version 200-301 Dumps

Try 200-301 Dumps Demo