RIPng is an extension of RIP developed for support of IPv6. Here are some of its features:

  • just like RIP for IPv4, it uses hop count as the metric
  • sends updates every 30 seconds
  • RIPng messages use the UDP port 521 and the multicast address of FF02::9


The configuration of RIPng is requires at least two steps:

1. enable RIPng using the global configuration command ipv6 router rip tag. The tag is used to differentiate between multiple RIP processes. It does not have to be the same on all routers in order to exchange routing information..
2. enable the routing protocol on the interface using the ipv6 rip tag enable. The tag has to match the one used in the ipv6 router rip tag command.

Here is an example:

ripng configuration

We have done a similar configuration on the second router. To verify that routers are indeed exchanging route information using RIPng we can use the show ipv6 route command:

show ipv6 route

In the picture above, we can see that the router has received a route to the network 2001:BBBB:CCCC:DDDD::/64.

Prerequisites for 200-301

200-301 is a single exam, consisting of about 120 questions. It covers a wide range of topics, such as routing and switching, security, wireless networking, and even some programming concepts. As with other Cisco certifications, you can take it at any of the Pearson VUE certification centers.

The recommended training program that can be taken at a Cisco academy is called Implementing and Administering Cisco Solutions (CCNA). The successful completion of a training course will get you a training badge.

Full Version 200-301 Dumps

Try 200-301 Dumps Demo