Interface status codes

Interface status codes can tell you whether an interface on a Cisco router or a switch is working. Status codes of an interface can be displayed using the show interface TYPE command, e.g.:

SW1#show interface fa0/1
FastEthernet0/1 is up, line protocol is up (connected)
  Hardware is Lance, address is 0060.70d8.0001 (bia 0060.70d8.0001)
 BW 100000 Kbit, DLY 1000 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)

The first line of the output indicates the working state of the interface. The first status code (known as line status) indicates that the Layer 1 is working (FastEthernet0/1 is up). The second status code (known as protocol status) indicates that Layer 2 is also working (line protocol is up) and is always Down if the line status is Down. Finally, the word at the end of the line indicates the working state of the interface (connected in our case).

All possible combinations of the status codes are given in the table below:

Cisco interface status codes

Only interfaces with status codes of up and up will forward or receive frames.

Prerequisites for 200-301

200-301 is a single exam, consisting of about 120 questions. It covers a wide range of topics, such as routing and switching, security, wireless networking, and even some programming concepts. As with other Cisco certifications, you can take it at any of the Pearson VUE certification centers.

The recommended training program that can be taken at a Cisco academy is called Implementing and Administering Cisco Solutions (CCNA). The successful completion of a training course will get you a training badge.

Full Version 200-301 Dumps

Try 200-301 Dumps Demo