EIGRP automatic & manual summarization

Route summarization is a method of representing multiple networks with a single summary address. It is often use in large networks with many subnets because it reduces the number of routes that a router must maintain and minimizes the traffic used for routing updates. Two methods for summarizing routes exist: automatic summarization and manual summarization.

EIGRP automatic summarization

By default, EIGRP has the auto summary feature enabled. Because of this, routes are summarized to classful address at network boundaries in the routing updates.

To better understand the concept of auto-summarization, consider the following example.

eigrp auto summary topology

Router R1 and R2 are running EIGRP. Router R1 has the locally connected subnet that is advertised to the router R2. Because of the auto summary feature, the router R1 summarizes the network before sending the route to R2. With the auto summary feature turned on, R1 sends the classful route to R2 instead of the more specific route.

On R1, we have configured the following network statement:

eigrp classful network

But, because of the auto-summary feature, R2 receives the route to the classful network

eigrp show ip route classful

The auto summary feature can cause problems with discontiguous networks. This is why this feature is usually turned off. This is done by using the no auto-summary command:

eigrp no auto summary

Now R2 has the classless route to reach the subnet

eigrp show ip route classless

After typing the no auto-summary command, the neighbor relationship will be re-established.

EIGRP manual summarization

One of the advantages of EIGRP over some other routing protocols (like OSPF) is that manual summarization can be done on any router within a network. A single route can be used to represent multiple routes, which reduces the size of routing tables in a network.

Manual summarization is configured on a per-interface basis. The syntax of the command is:

(config-if) ip summary-address eigrp ASN SUMMARY_ADDRESS SUBNET_MASK

An example will help you to understand the concept of manual summarization:

eigrp manual summary topology

Router R1 and R2 are running EIGRP. Router R1 (on the left) has two directly connected subnets: and EIGRP advertises these subnets as two separate routes. R2 now has two routes for two subnets, which can be confirmed by using the show ip route command on R2:

show ip route no manual summary

We could configure R1 to advertise only one summary route for both subnets, which helps reduce R2’s routing table. To do this, the following command can be used:
eigrp manual summary

Now, R1 is sending only one route to reach both subnets to R2. We can verify that by using the show ip route command on R2:

show ip route manual summary
Now R2 has only one route to reach both subnets on R1.

In the example above, the ip summary command included two subnets on R1, but also some other addresses that are not in these subnets. The range of the summarized addresses is –, so R2 thinks that R1 has the routes for all addresses inside that range. That could cause some problems if these addresses exist somewhere else in the network.

Prerequisites for 200-301

200-301 is a single exam, consisting of about 120 questions. It covers a wide range of topics, such as routing and switching, security, wireless networking, and even some programming concepts. As with other Cisco certifications, you can take it at any of the Pearson VUE certification centers.

The recommended training program that can be taken at a Cisco academy is called Implementing and Administering Cisco Solutions (CCNA). The successful completion of a training course will get you a training badge.

Full Version 200-301 Dumps

Try 200-301 Dumps Demo