200-150 Real Exam Dumps Questions and answers 51-60

Get Full Version of the Exam

Question No.51

Which statement describes the uses of zones in a VSAN?

  1. Zones are configured at the fabric core.

  2. An HBA or storage device can only belong to zone.

  3. Zones limit unicast, multicast, and broadcast traffic.

  4. Zones are a group of sports within a single VSAN.

Correct Answer: C

Question No.52

Which type of media uses electromagnetic waves that are generated by lasers, is often used in campus backbones, and is capable of transmitting to a distance of 60 kilometers?

  1. shielded twisted-pair cable

  2. coaxial cable

  3. multimode fiber-optic cable

  4. single-mode fiber-optic cable

Correct Answer: C

Question No.53

Which two options are block-based storage protocols? (Choose two.)

  1. NFS

  2. iSCSI

  3. NAS

  4. FCoE

  5. CIFS

Correct Answer: BD

Question No.54

Which two port types are needed to build out an FCoE pass-through switch in NPV mode while maintaining Fiber Channel packet visibility? (Choose two.)

  1. VN Port

  2. VE Port

  3. VF Port

  4. Edge Port

  5. N Port

Correct Answer: AC

Question No.55

Which three layers of the OSI model are included in the application layer of the TCP/IP model? (Choose three.)











Correct Answer: ABD

Question No.56

Refer to the exhibit. How does the switch process the Ethernet frame?


  1. drop the frame

  2. Forwards the frame to port3

  3. filter the frame

  4. floods the frame

Correct Answer: B

Question No.57

A network engineer is verifying Layer 2 connectivity of a server to a Cisco Nexus switch by checking the Address Resolution table statistics. Which command shows the MAC address, physical interfaced, VLAN and IP address of a server on a Cisco Nexus switch?

  1. show Ip arp interface

  2. show Ip arp

  3. show Ip arp detail

  4. show arp detail

Correct Answer: C

Question No.58

Refer to the exhibit. What is the result when you run the command? datacenter(config)# zoneset activate name ZS vsan 20

  1. All switches in the fabric receive the active zone set.

  2. The zone set is activated on the switch only.

  3. On the reboot, all switches in the fabric receives the active zone set.

  4. The default zone set is activated on all switches in the fabric.

Correct Answer: B

Question No.59

Which device would you select to partition a network into VLANs?

  1. repeater

  2. bridge

  3. switch

  4. router

  5. hub

Correct Answer: C

Question No.60

What is the minimum number of fabric modules that should be installed in the Cisco Ne*js 7000 chassis for N 1 redundancy using Ml-Series line card?









Correct Answer: A

Get Full Version of 200-150 Dumps