Power on a Cisco device

When you first power-on a newly purchashed Cisco device, it will perform a power-on self-test (POST) to discover the hardware components and verify that all components work properly. If the POST is successful, the device will enter the setup mode. This mode presents a step-by-step dialog to help you configure some basic parameters, such as the device hostname, passwords, interface IP address, etc. To enter the setup mode, power on your device and type yes when prompted to make a selection:

ios setup mode

The wizard guides you through the initial configuration of your device and will create an initial configuration file. The setup mode is useful when you are unfamiliar with the IOS CLI, but once you learn the basics of CLI, you probably won’t use this mode ever again.

NOTE
You can enter the setup mode at any time from the command line by typing the setup command from the privileged mode. To exit the setup mode without saving any changes, press CRTL+C.

Prerequisites for 200-301

200-301 is a single exam, consisting of about 120 questions. It covers a wide range of topics, such as routing and switching, security, wireless networking, and even some programming concepts. As with other Cisco certifications, you can take it at any of the Pearson VUE certification centers.

The recommended training program that can be taken at a Cisco academy is called Implementing and Administering Cisco Solutions (CCNA). The successful completion of a training course will get you a training badge.

Full Version 200-301 Dumps

Try 200-301 Dumps Demo