Configuring voice VLANs

Most corporate networks today use IP telephony. This means that the phones are connect to the same network and use the same cabling as other network devices, such as workstations or routers. Since offices usually have only a single UTP cable to each desk, most of the IP phones today include a small switch that enable you to connect your PC to the phone sitting on the desk, and then connect the phone to the local network.

Consider the backside of an IP telephone Yealink T21:

Yealink T21 backside

As you can see from the picture, this phone has two UTP ports. One port is connected to the local network, while the other port can be connected to the PC.

The port on the phone connected to the switch can carry both data and voice traffic. To enable this, we need to define two VLANs on the switch port – data VLAN and voice VLAN. Here is how we can do that:

SW1(config)#vlan 5
SW1(config)#vlan 20
SW1(config)#int fa0/1
SW1(config-if)#switchport mode access
SW1(config-if)#switchport access vlan 5
SW1(config-if)#switchport voice vlan 20

We’ve created two VLANs – VLAN 5 that will be used for data sent by the PC and VLAN 20 for IP phone’s voice traffic. We’ve then placed the port into both VLANs. The keyword voice indicates that the VLAN 20 will be a voice VLAN.

To verify that the interface indeed carries data from both VLANs, we can use the show interfaces Fa0/1 switchport command:

Switch#show interfaces fa0/1 switchport
Name: Fa0/1
Switchport: Enabled
Administrative Mode: static access
Operational Mode: static access
Administrative Trunking Encapsulation: dot1q
Operational Trunking Encapsulation: native
Negotiation of Trunking: Off
Access Mode VLAN: 5 (VLAN0005)
Trunking Native Mode VLAN: 1 (default)
Voice VLAN: 20
Administrative private-vlan host-association: none
Administrative private-vlan mapping: none
...

The lines Access Mode VLAN: 5 (VLAN0005) and Voice VLAN: 20 indicate that the interface is indeed carrying traffic from both VLANs.

NOTE
Some IP phones can be automatically configured with appropriate VLANs using protocols such as LLDP or CDP. However, on some models you will need to manually configure data and voice VLANs on the phone using its web interface.

Prerequisites for 200-301

200-301 is a single exam, consisting of about 120 questions. It covers a wide range of topics, such as routing and switching, security, wireless networking, and even some programming concepts. As with other Cisco certifications, you can take it at any of the Pearson VUE certification centers.

The recommended training program that can be taken at a Cisco academy is called Implementing and Administering Cisco Solutions (CCNA). The successful completion of a training course will get you a training badge.

Full Version 200-301 Dumps

Try 200-301 Dumps Demo